P0010

P0010: Intake camshaft actuator circuit fault, bank 1

For your specific vehicle: P0010 on a 2010–2017 Chevrolet Equinox

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The electric valve that adjusts your intake camshaft timing on the cylinder-1 side has an electrical fault - usually a bad solenoid or damaged wiring. The engine runs, but with the cam timing stuck in one position.

Model notes: Very common code across Toyota, GM, Ford, Honda, VW/Audi, Hyundai. On some engines the solenoid screens clog with sludge - cleaning can work, but replacement is more reliable.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. With the engine warm, inspect the bank 1 intake VVT solenoid wiring and connector for damage, corrosion, or loose pins, and repair as needed Tests: Failed VVT oil control valve (solenoid) for the bank 1 intake camshaft (most common)
  2. Check the fuse feeding the VVT solenoid circuit Tests: Blown fuse feeding the solenoid circuit
  3. Unplug the solenoid and measure its internal resistance against the factory specification - an open or shorted winding means replacement Tests: Open or shorted wiring in the VVT actuator circuit, including rodent damage
  4. Check the harness for continuity back to the PCM and for shorts to ground or power
  5. Command the solenoid on and off with a bi-directional scan tool if available and listen/feel for the click
  6. Clear the code and retest; if the circuit is good and the code returns, suspect the PCM driver

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $150
Labor$80 – $250

VVT oil control valve (solenoid) replacement for the bank 1 intake camshaft. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0010 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — The VVT solenoid is usually an accessible bolt-on part; the main work is confirming it's the solenoid and not the wiring.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →