Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonA fuel shutoff that can't open leaves you with a no-start - worth diagnosing before it strands you.
Can I drive with P0006?
Can I drive with a P0006 code?
Short trips and gentle driving only, until you know the cause. A fuel shutoff that can't open leaves you with a no-start - worth diagnosing before it strands you. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0006?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. A fuel shutoff that can't open leaves you with a no-start - worth diagnosing before it strands you.
Will P0006 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The wire controlling your fuel shutoff valve is shorted to ground. The valve may not open, which can mean a crank-but-no-start situation.
Key facts
P0006 means fuel shutoff valve A control circuit low. The wire controlling your fuel shutoff valve is shorted to ground. The valve may not open, which can mean a crank-but-no-start situation. WrenchFair's published fair-price range for this repair is $60–$250 parts and $120–$300 labor at independent shops.
WrenchFair rates P0006 a 3-of-5 DIY difficulty (“Standard short-to-ground hunting with a multimeter, but factory documentation for this rare code is hard to come by.”) with a “Diagnose soon” driveability rating: A fuel shutoff that can't open leaves you with a no-start - worth diagnosing before it strands you. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
crank but no start
intermittent stalling
Likely causes
Control wire shorted to ground (chafed harness)
Shorted fuel shutoff valve solenoid winding
Corroded connector bridging the circuit to ground
Failed PCM driver (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fuse for the shutoff valve circuit Tests: Shorted fuel shutoff valve solenoid winding
Unplug the valve and see if the low-voltage reading clears - if it does, the valve is shorted Tests: Shorted fuel shutoff valve solenoid winding
With the valve unplugged, test the control wire for continuity to ground and repair any chafed section Tests: Control wire shorted to ground (chafed harness)
Measure the valve solenoid resistance against factory spec Tests: Shorted fuel shutoff valve solenoid winding
Inspect connectors for moisture or corrosion bridging terminals
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $250
Labor$120 – $300
Fuel shutoff valve replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0006 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Standard short-to-ground hunting with a multimeter, but factory documentation for this rare code is hard to come by.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →