C0277

C0277: Brake Booster Vacuum Sensor Circuit Malfunction

For your specific vehicle: C0277 on a 2016–2019 Chevrolet Malibu

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

A sensor that monitors your brake booster isn't sending a believable signal. Your brakes still work, but the pedal may feel harder than usual and ABS or stability control may be switched off.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Clear the code and re-scan after a short drive to confirm it is a hard fault.
  2. 2. Check the vacuum hose to the booster for cracks, collapsing, or a failed check valve, and listen for a hissing leak with the engine running. Tests: vacuum leak in the booster hose or check valve
  3. 3. Unplug the sensor and check the connector for corrosion or bent pins.
  4. 4. Check the sensor wiring back toward the module for chafing or breaks. Tests: wiring fault to the sensor
  5. 5. If the wiring is good, replace the sensor. If the new sensor still faults, the booster assembly itself is suspect.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$60 – $250
Labor$100 – $300

A brake booster sensor replacement, roughly $150-$400 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0277 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Sensor and hose checks are straightforward; booster replacement is a bigger job best left to a shop.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →