C0069

C0069: Yaw Rate/Longitude Sensors

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

A sensor that tells your car how it is moving (yaw rate / longitudinal acceleration sensor cluster) isn't sending a believable signal. Your normal brakes work fine, but stability control is switched off, so the car won't help correct a skid.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Scan all modules and fix any other sensor codes first - one bad sensor can make the module distrust this one. Tests: module fault is possible but uncommon - rule out wiring, mounting, and calibration first
  2. 2. Check whether the car recently had an alignment, suspension, or collision work: lost calibration is the most common cause. Tests: sensor calibration lost after alignment or suspension work - recalibrate before replacing…
  3. 3. Inspect the yaw rate / longitudinal acceleration sensor cluster mounting and connector for looseness, corrosion, or damage. Tests: yaw rate / longitudinal acceleration sensor cluster failed
  4. 4. With a scan tool, read the yaw rate / longitudinal acceleration sensor cluster live data and compare it to reality (straight road, level ground, wheels straight). Tests: yaw rate / longitudinal acceleration sensor cluster failed
  5. 5. Run the sensor calibration or zero-point learn procedure with a scan tool that supports it.
  6. 6. If it won't calibrate or the signal stays wrong, replace the yaw rate / longitudinal acceleration sensor cluster and calibrate the new one.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $400
Labor$120 – $350

A yaw or acceleration sensor replacement with calibration, roughly $250-$600 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0069 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Inspection and calibration checks are DIY-friendly; replacement often needs a scan tool with a calibration routine.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →