B0084

B0084: Second row center seatbelt load limiter deployment control circuit fault

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car's airbag computer found an electrical problem in the second-row center seatbelt's load limiter - the mechanism that lets the belt give a controlled amount in a crash to protect your chest. The airbag warning light will stay on. The belt still holds you normally in everyday driving.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Disconnect the battery (negative terminal first) and wait at least 10 minutes before touching any SRS connector or component. Tests: Damaged wiring or connector to the second-row center retractor (most common - under-seat…
  2. Read the code with an SRS-capable scan tool and note any subcode digits after the main code (e.g. -11, -12, -13) - many makes append them to say open circuit, short to ground, short to battery, or wires shorted together.
  3. With power still off, inspect the second-row center retractor wiring and connectors (usually at the base of the B-pillar or under the seat) for damage, pinching, or corrosion. Tests: Damaged wiring or connector to the second-row center retractor (most common - under-seat…
  4. Check for signs of prior deployment or crash damage to the retractor - a fired unit must be replaced. Tests: A previously deployed or damaged retractor that was never replaced - check crash history
  5. Test the circuit only with the battery disconnected and only per the factory service manual's SRS procedure - never apply power to or probe a live deployment circuit.
  6. Verify the restraints control module's power and ground feeds, repair the fault, reconnect the battery, clear the code, and confirm the airbag light completes its power-on self-test.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$150 – $450
Labor$150 – $350

Wiring/connector repair, or seatbelt retractor assembly replacement if the load limiter element failed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for B0084 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — The load limiter lives inside the retractor; diagnosis is inspection and multimeter work after the mandatory battery disconnect, and replacement is a bolt-in job.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →