B0050

B0050: Driver seatbelt buckle sensor circuit fault

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car's airbag computer can't reliably tell whether the driver's seatbelt is buckled - the little switch inside the buckle has an electrical problem. The airbag warning light will stay on, and the belt reminder may chime or flash even when the belt is buckled. The belt itself still holds you normally.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Disconnect the battery (negative terminal first) and wait at least 10 minutes before touching any SRS connector or component. Tests: Corroded or loose connector under the seat
  2. Read the code with an SRS-capable scan tool and note any subcode digits after the main code (e.g. -11, -12, -13) - many makes append them to say open circuit, short to ground, short to battery, or wires shorted together.
  3. With power still off, inspect the driver's buckle and its wiring under the seat - slide the seat fully forward and back and look for pinched, cut, or corroded wires and connectors. Tests: Damaged wiring under the seat - kicked, pinched by the seat track, or chewed
  4. Blow out and clean any debris from inside the buckle; confirm the buckle latches and releases crisply. Tests: Debris, crumbs, or sticky liquid jammed inside the buckle
  5. Test the buckle switch (continuity buckled vs. unbuckled) per the factory service manual; replace the buckle assembly if the switch is bad.
  6. Verify the restraints control module's power and ground feeds, repair the fault, reconnect the battery, clear the code, and confirm the airbag light completes its power-on self-test.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$60 – $250
Labor$100 – $250

Seatbelt buckle assembly replacement (the switch is part of the buckle). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for B0050 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Buckle assemblies are bolted to the seat or floor and swap with basic hand tools; the only SRS-specific care is the battery disconnect first.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →