B0058: Third row right seatbelt buckle sensor circuit fault
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe car drives normally, but the affected restraint may not protect you in a crash - get it diagnosed promptly.
Your car's airbag computer can't reliably tell whether the third-row right seatbelt is buckled - the little switch inside the buckle has an electrical problem. The airbag warning light will stay on, and the belt reminder may chime or flash even when the belt is buckled. The belt itself still holds you normally.
Key facts
B0058 means third row right seatbelt buckle sensor circuit fault. Your car's airbag computer can't reliably tell whether the third-row right seatbelt is buckled - the little switch inside the buckle has an electrical problem. The airbag warning light will stay on, and the belt reminder may chime or flash even when the belt is buckled. The belt itself still holds you normally. WrenchFair's published fair-price range for this repair is $60–$250 parts and $100–$250 labor at independent shops.
WrenchFair rates B0058 a 2-of-5 DIY difficulty (“Buckle assemblies are bolted to the seat or floor and swap with basic hand tools; the only SRS-specific care is the battery disconnect first.”) with a “Diagnose soon” driveability rating: The car drives normally, but the affected restraint may not protect you in a crash - get it diagnosed promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
airbag warning light on
seat belt warning light on with the belt buckled
seat belt chime sounds with the belt buckled
passenger airbag indicator behaving incorrectly
Likely causes
Worn-out buckle switch in the third-row right buckle assembly (most common - the switch simply wears out with use)
Damaged wiring under the seat - kicked, pinched by the seat track, or chewed
Corroded or loose connector under the seat
Debris, crumbs, or sticky liquid jammed inside the buckle
Restraints control module fault (rare - diagnose everything else first)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Disconnect the battery (negative terminal first) and wait at least 10 minutes before touching any SRS connector or component. Tests: Corroded or loose connector under the seat
Read the code with an SRS-capable scan tool and note any subcode digits after the main code (e.g. -11, -12, -13) - many makes append them to say open circuit, short to ground, short to battery, or wires shorted together.
With power still off, inspect the third-row right buckle and its wiring under the seat - slide the seat fully forward and back and look for pinched, cut, or corroded wires and connectors. Tests: Damaged wiring under the seat - kicked, pinched by the seat track, or chewed
Blow out and clean any debris from inside the buckle; confirm the buckle latches and releases crisply. Tests: Debris, crumbs, or sticky liquid jammed inside the buckle
Test the buckle switch (continuity buckled vs. unbuckled) per the factory service manual; replace the buckle assembly if the switch is bad.
Verify the restraints control module's power and ground feeds, repair the fault, reconnect the battery, clear the code, and confirm the airbag light completes its power-on self-test.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $250
Labor$100 – $250
Seatbelt buckle assembly replacement (the switch is part of the buckle). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for B0058 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Buckle assemblies are bolted to the seat or floor and swap with basic hand tools; the only SRS-specific care is the battery disconnect first.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →