TPMS light stays on — the tire-pressure warning that won't clear

The little horseshoe-with-an-exclamation light came on and won't go away. The tires look fine to the eye — and they would, because you can't see a tire that's 25% low by looking at it. The TPMS system is either telling the truth (pressure is off), can't hear a sensor anymore, or was never re-taught after the tires were moved around.

Most likely causes, in check-order

Cheapest and easiest first. Don't buy parts until the checks below point at one.

1. Actually low tire pressure

The most common real cause, especially with a cold snap — pressure drops as temperatures fall, and the light trips. Check pressures cold with a gauge against the door-jamb sticker, not the tire sidewall. 'Looks fine' isn't a measurement.

2. Dead sensor battery

Each wheel's sensor has a small battery that lasts roughly 5–10 years. A car from the mid-2010s with original sensors is right in the replacement window. One dead sensor keeps the light on permanently, and it needs a new sensor, not air.

3. Relearn needed after rotation or new tires

Many cars need a relearn procedure after tires are rotated or replaced so the car knows which sensor is where. If the light appeared right after tire work, this is the cause — some cars relearn by driving, some need a tool or a dash-menu sequence.

4. The spare has a sensor too

On some vehicles the spare tire carries a sensor. A low spare trips the light while all four driven wheels check out — the classic 'but I checked them all' case.

5. Flashing vs solid matters

A light that flashes for a minute then goes solid usually means a system fault (dead sensor, module issue); a light that comes on solid means a pressure issue. That split tells you whether to reach for the air hose or the sensor.

Driveway checks

Related