You start the car and get a loud squeal or chirp that fades after a few seconds — or doesn't fade at all. That noise is the serpentine belt or something it drives. The belt runs the alternator, power steering, A/C, and often the water pump, so this sound deserves attention even when the car drives fine.
Cheapest and easiest first. Don't buy parts until the checks below point at one.
Belts harden with age and heat cycles, and the ribs lose their grip. A belt that squeals for a few seconds on a cold or damp start and then quiets is the early stage — the grip comes back as it warms and dries.
The spring-loaded tensioner keeps the belt tight. As its spring tires, the belt slips under load — worst right at startup, when the alternator works hardest to recharge the battery.
Idler pulleys, the tensioner pulley, and accessory bearings chirp and squeal as they wear out. Bearing noise is more of a chirp or growl that follows engine RPM and doesn't care about weather.
Oil, coolant, or power steering fluid leaking onto the belt makes it slip and squeal — and ruins the new belt too if the leak isn't fixed. Shiny wet patches in the belt area are the clue.
An accessory that's starting to seize loads the belt the moment it engages. Squeal that starts exactly when the A/C kicks on points at the compressor side of the circuit.
If the squeal is joined by a battery warning light, heavy steering, or a rising temperature gauge, the belt may have come off entirely — stop driving. Without the belt there's no charging, often no power steering assist, and frequently no water pump, which means overheating within minutes. See the battery/charging light guide.