Clicking noise when turning — the CV joint test

A rhythmic click-click-click when you turn — loudest on sharp, slow turns like parking lots. On a front-wheel-drive car, that sound has one classic source, and there's a 60-second test that confirms it.

Most likely causes, in check-order

Cheapest and easiest first. Don't buy parts until the checks below point at one.

1. Worn outer CV joint

The signature cause. The protective boot tears, grease escapes, grit gets in, and the joint wears until it clicks at full steering angle. It's the outside joint on the side you're turning toward that usually goes first — but check both.

2. Loose lug nuts

Check this FIRST. A wheel working loose clicks and clunks, and it can come off. If you've had recent tire or brake work, grab the lug wrench before anything else.

3. Worn brake hardware

A light metallic tick at low speed, sometimes right after releasing the brakes — a shifting pad or loose anti-rattle clip rather than a joint.

Driveway checks

⛔ Stop driving and tow it

A clicking CV joint can be driven to a shop — but a joint that's clunking violently or an axle that's separated means no drive power and possible loss of control. If the noise suddenly gets much worse, or you feel binding or vibration with it, stop and tow. And if the lug nuts were loose, don't drive until they're properly torqued.

Related