The fan does nothing on low, medium-low, or medium — then roars to life on high. The air is the right temperature; it just won't blow gently. This all-or-nothing pattern is one of the most specific symptoms in car HVAC: high speed bypasses the speed-control circuit entirely, so when only high works, the speed control is what's dead.
Cheapest and easiest first. Don't buy parts until the checks below point at one.
The classic cause on manual HVAC systems. The resistor pack drops voltage to make the lower speeds; when it burns out, only the direct high-speed circuit survives. It's a common, inexpensive part, usually mounted in the duct near the blower motor.
Cars with automatic climate control use an electronic module instead of a resistor pack. Same symptom, different part — and the module is usually pricier.
Resistors often die because the aging blower motor draws too much current. If the new resistor burns out again quickly, the motor is the real problem — listen for squealing or sluggishness from the fan.
Heat from a failing resistor or an overworked motor melts the wiring connector. If the replacement doesn't fix it, inspect the plug — a melted connector needs repair too.
Worth knowing the boundary: if NO speed works, not even high, that's the fuse, relay, or the motor itself — a different list than this page.