U3016

U3016: Control Module Ground D

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car's computer module can't get a clean ground connection on its ground D wire - usually a corroded bolt, a loose strap, or a rusty ground point. Modules with bad grounds act erratically or shut down.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the battery and charging system first - weak system voltage mimics ground problems. Tests: Failed control module (last resort - grounds are almost always the real problem)
  2. Use a wiring diagram to locate the module's ground D point. Tests: Ground point shared with another high-draw circuit causing a ground offset
  3. Remove the ground bolt, clean the terminal and the mounting surface to bare metal, and re-torque it snug. Tests: Corroded or loose ground bolt for the module (most common - grounds rot where salt and…
  4. Inspect the ground wire itself for internal corrosion or breakage where it flexes. Tests: Broken ground strap or damaged ground wire
  5. Check continuity from the module connector's ground pin to battery negative, then clear the code and retest.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$10 – $230
Labor$50 – $250

Ground point cleaning and re-torque. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U3016 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Ground bolts are usually accessible and cleaning one is a beginner job; finding which ground the code refers to is the real work.

Watch this repair on YouTube

Parts & tools

Electrical diagnosis toolkit — what the job actually takes

Torque specs: Module connectors: hand-tight until they click — never force them.

Pro tip: Check powers AND grounds before condemning a module — most “module failures” are wiring. Disconnect the battery before unplugging modules.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →