U064F: Lost communication with intake manifold runner position sensor bank 1
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonPerformance is slightly reduced — drivable, fix it when convenient.
Inside your intake manifold are little flaps that change shape for better power and economy, and a sensor reports where they are. It went silent. You might notice less low-end pep or a check engine light.
Key facts
U064F means lost communication with intake manifold runner position sensor bank 1. Inside your intake manifold are little flaps that change shape for better power and economy, and a sensor reports where they are. It went silent. You might notice less low-end pep or a check engine light. WrenchFair's published fair-price range for this repair is $80–$300 parts and $150–$300 labor at independent shops.
WrenchFair rates U064F a 3-of-5 DIY difficulty (“Often part of the intake manifold assembly — check whether the flaps move freely before replacing parts.”) with a “Diagnose soon” driveability rating: Performance is slightly reduced — drivable, fix it when convenient. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
loss of low-end power
rough idle
worse fuel economy
Likely causes
failed runner position sensor
carbon-seized intake flaps
failed runner actuator
damaged wiring
corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Locate the runner actuator on the bank 1 intake manifold and check its connector. Tests: failed runner actuator
Watch runner position on a scan tool while revving the engine. Tests: failed runner position sensor
Clean, repair, or replace the sensor/actuator as needed; clear and retest. Tests: failed runner actuator
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $300
Labor$150 – $300
Replacing the intake manifold runner position sensor or actuator. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U064F ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Often part of the intake manifold assembly — check whether the flaps move freely before replacing parts.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →