U0640: Lost communication with EVAP fuel vapor temperature sensor circuit
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonEmissions monitoring only — safe to drive, fix it before your emissions test.
Your car traps gas fumes so they don't escape, and a sensor measures the temperature of those fumes. It went quiet. You'll get a check engine light — the car drives normally, but it may not pass an emissions test.
Key facts
U0640 means lost communication with EVAP fuel vapor temperature sensor circuit. Your car traps gas fumes so they don't escape, and a sensor measures the temperature of those fumes. It went quiet. You'll get a check engine light — the car drives normally, but it may not pass an emissions test. WrenchFair's published fair-price range for this repair is $40–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates U0640 a 2-of-5 DIY difficulty (“Near the fuel tank or charcoal canister — inspect the EVAP hoses for cracks while you're under there.”) with a “Diagnose soon” driveability rating: Emissions monitoring only — safe to drive, fix it before your emissions test. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
failed emissions test
no noticeable symptoms
Likely causes
failed vapor temperature sensor
corroded connector
damaged wiring near the tank
engine computer communication fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Locate the sensor near the fuel tank or EVAP canister and check its connector. Tests: damaged wiring near the tank
Inspect EVAP hoses for cracks or disconnections.
Compare its reading to ambient on a cold engine.
Replace the sensor if wiring is good; clear and retest.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $120
Labor$80 – $180
Replacing the EVAP fuel vapor temperature sensor. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U0640 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Near the fuel tank or charcoal canister — inspect the EVAP hoses for cracks while you're under there.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →