Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe engine runs fine on backup values - fix at your convenience.
The sensor measuring temperature inside your crankcase is reporting a circuit fault. The computer uses it for cold-start and oil-condition strategies.
Key facts
P2EBE means crankcase Temperature Sensor Circuit Low. The sensor measuring temperature inside your crankcase is reporting a circuit fault. The computer uses it for cold-start and oil-condition strategies. WrenchFair's published fair-price range for this repair is $40–$150 parts and $100–$250 labor at independent shops.
WrenchFair rates P2EBE a 2-of-5 DIY difficulty (“Simple sensor diagnosis and replacement - access is the only variable.”) with a “Diagnose soon” driveability rating: The engine runs fine on backup values - fix at your convenience. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
sensor reading stuck or erratic
slightly off cold-start behavior
Likely causes
Failed temperature sensor (most common)
Oil intrusion into the connector
Damaged wiring
Lost reference voltage or ground
signal wire shorted to ground
internal sensor short
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code and log the sensor's reading cold - it should read near ambient.
Inspect the sensor and its connector for oil intrusion and wiring damage. Tests: Oil intrusion into the connector
Check the sensor's reference and ground circuits. Tests: Lost reference voltage or ground
Replace the sensor if its reading is wrong with good wiring.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$100 – $250
Crankcase temperature sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2EBE ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Simple sensor diagnosis and replacement - access is the only variable.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →