P2E9F

P2E9F: Charge Port Door B Unlock Control Circuit Low

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The motorized door covering your charge port (B) is reporting a low control circuit signal. Charging itself is usually fine once the door is open.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Try operating the door manually - check for ice, debris, or physical damage jamming it. Tests: Jammed door from ice, debris, or bent linkage (most common)
  2. Watch the door position PID on a scan tool while operating the door. Tests: Failed position sensor
  3. Inspect the door motor, linkage, and wiring for damage or corrosion. Tests: Jammed door from ice, debris, or bent linkage (most common)
  4. Lubricate or free the mechanism if it is stiff; replace the motor or sensor if it will not report correctly.
  5. Verify the door opens, closes, and locks through several cycles.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$150 – $500
Labor$150 – $350

Charge port door motor or position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2E9F ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Mostly mechanical - freeing or swapping a small door motor is basic trim work.

Watch this repair on YouTube

Parts & tools

Battery & charging toolkit — what the job actually takes

Torque specs: Terminal clamps: snug, typically 5–8 Nm. Over-tightening cracks the battery post.

Pro tip: Disconnect negative first, reconnect negative last. On module-heavy cars use a memory saver so you don’t lose radio codes and adaptations.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →