P2E45

P2E45: Hybrid/EV Electronics Coolant Pump B Enable Circuit

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your high-voltage battery and power electronics are liquid-cooled, and the computer says that cooling system is not doing its job - a circuit fault.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. High-voltage safety first: this code lives in the high-voltage system, which can carry lethal voltage. Only touch it if you are trained and equipped for HV service (insulated tools, HV gloves, service-plug procedure); everyone else should stop at scanning and hand the repair to a qualified EV/hybrid technician.
  2. Scan and record battery and electronics coolant temperatures, pump speeds, and any leak-detection PIDs. Tests: Failed electric coolant pump (most common)
  3. Check the coolant level in the battery/electronics loop and look under the car for coolant - the leak code means a real leak until proven otherwise. Tests: Coolant leak at a fitting, hose, or the chiller
  4. Command the coolant pump on with a scan tool and verify it actually runs at the commanded speed. Tests: Failed electric coolant pump (most common)
  5. Inspect pump wiring and connectors, and check the pump's fuse/driver.
  6. Repair the leak or replace the failed pump, bleed the loop per the factory procedure, and verify temperatures normalize under load.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$150 – $800
Labor$200 – $500

Battery/electronics coolant pump replacement or leak repair with system bleed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2E45 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Pump and leak checks are approachable, but the loop runs next to high-voltage components and bleeding it correctly matters.

Watch this repair on YouTube

Parts & tools

Battery & charging toolkit — what the job actually takes

Torque specs: Terminal clamps: snug, typically 5–8 Nm. Over-tightening cracks the battery post.

Pro tip: Disconnect negative first, reconnect negative last. On module-heavy cars use a memory saver so you don’t lose radio codes and adaptations.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →