Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonFuel metering runs on backup values while the sensors disagree - economy suffers, so don't sit on it.
Your car has two fuel temperature sensors and they disagree. One of them is reading wrong.
Key facts
P2D86 means fuel Temperature Sensor A/B Correlation. Your car has two fuel temperature sensors and they disagree. One of them is reading wrong. WrenchFair's published fair-price range for this repair is $40–$150 parts and $100–$250 labor at independent shops.
WrenchFair rates P2D86 a 2-of-5 DIY difficulty (“Comparing two sensor readings is easy scan-tool work; the sensor swap is usually one connector.”) with a “Diagnose soon” driveability rating: Fuel metering runs on backup values while the sensors disagree - economy suffers, so don't sit on it. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
slightly worse fuel economy
sensor readings disagreeing on the scan tool
Likely causes
Drifted or failed fuel temperature sensor (most common)
Damaged wiring or corroded connector
Sensor contaminated by fuel additives or debris
one sensor characteristic drifted
harness incorrectly swapped between channels
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code and log both fuel temperature sensors on a cold soak - they should read near ambient. Tests: Drifted or failed fuel temperature sensor (most common)
The sensor that disagrees with ambient (check with a real thermometer) is the faulty one.
Inspect that sensor's wiring and connector for damage or corrosion. Tests: Damaged wiring or corroded connector
Replace the faulty sensor and verify both agree after a cold soak.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$100 – $250
Fuel temperature sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2D86 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Comparing two sensor readings is easy scan-tool work; the sensor swap is usually one connector.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →