P2D03: Motor Electronics Coolant Pump A Supply Voltage Circuit
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe inverter and motor electronics can overheat if the pump is truly dead - drive gently and fix it soon rather than ignoring it.
Your hybrid or EV has small electric pumps that circulate coolant through the inverter and drive-motor electronics. The car thinks pump a is a supply voltage circuit fault, so that cooling loop is not doing its job.
Key facts
P2D03 means motor Electronics Coolant Pump A Supply Voltage Circuit. Your hybrid or EV has small electric pumps that circulate coolant through the inverter and drive-motor electronics. The car thinks pump a is a supply voltage circuit fault, so that cooling loop is not doing its job. WrenchFair's published fair-price range for this repair is $150–$600 parts and $150–$400 labor at independent shops.
WrenchFair rates P2D03 a 3-of-5 DIY difficulty (“The diagnosis is straightforward scan-tool and multimeter work, but bleeding the electronics cooling loop properly takes patience.”) with a “Diagnose soon” driveability rating: The inverter and motor electronics can overheat if the pump is truly dead - drive gently and fix it soon rather than ignoring it. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine or hybrid system warning light on
reduced power or limited electric drive
electronics cooling temperature climbing on the scan tool
coolant pump noisy, silent, or running constantly
Likely causes
Low coolant or air trapped in the electronics cooling loop
Failed pump motor or jammed impeller
Corroded connector or damaged wiring at the pump
Blown fuse or failed pump relay/driver
Pump control module fault (rare - check everything else first)
supply fuse blown
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan and note freeze-frame data, then use the scan tool's output test to command the pump a on and listen/feel for it running.
Check the coolant level in the electronics cooling loop and look for air pockets - a low or air-bound loop makes pumps overspeed or stall. Tests: Low coolant or air trapped in the electronics cooling loop
Inspect the pump a connector and wiring for corrosion, chafing, or coolant intrusion. Tests: Corroded connector or damaged wiring at the pump
With the pump commanded on, verify power and ground are actually reaching the pump connector before condemning the pump. Tests: Corroded connector or damaged wiring at the pump
Replace the pump if it has power and ground but will not run correctly, then bleed the loop per the factory procedure and retest.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$150 – $600
Labor$150 – $400
Electric coolant pump replacement and cooling-loop bleed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2D03 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The diagnosis is straightforward scan-tool and multimeter work, but bleeding the electronics cooling loop properly takes patience.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →