P2BB9: Engine Coolant Temperature Sensor 6 Circuit High
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonA lying temperature sensor can mask a real overheat - verify actual coolant temperature before assuming it is just the sensor.
One of your engine's coolant temperature sensors (sensor 6) is giving a bad reading. The computer plays it safe - expect the fans to run more and possibly slightly worse fuel economy. Usually the sensor itself or its wiring.
Key facts
P2BB9 means engine Coolant Temperature Sensor 6 Circuit High. One of your engine's coolant temperature sensors (sensor 6) is giving a bad reading. The computer plays it safe - expect the fans to run more and possibly slightly worse fuel economy. Usually the sensor itself or its wiring. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$200 labor at independent shops.
WrenchFair rates P2BB9 a 2-of-5 DIY difficulty (“Check coolant level first, then it is a simple sensor swap - usually one of the easiest fixes.”) with a “Diagnose soon” driveability rating: A lying temperature sensor can mask a real overheat - verify actual coolant temperature before assuming it is just the sensor. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
cooling fans running more than usual
temperature gauge reading oddly
slightly worse fuel economy
Likely causes
Failed ECT sensor 6 (most common - they drift with age and heat cycling)
Damaged wiring or corroded connector
Low coolant or air pockets skewing the reading (check the level first)
Control module fault (rare - diagnose everything else first)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor.
Check the coolant level and bleed air from the system first - low coolant makes sensors lie. Tests: Low coolant or air pockets skewing the reading (check the level first)
Inspect the ECT sensor 6 wiring and connector for corrosion. Tests: Damaged wiring or corroded connector
Compare the sensor 6 reading against a plausible value and against the other ECT sensors. Tests: Low coolant or air pockets skewing the reading (check the level first)
Replace ECT sensor 6 if it reads wrong, bleed the system, clear the code, and confirm the reading tracks reality on a drive.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $120
Labor$80 – $200
Engine coolant temperature sensor 6 replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2BB9 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Check coolant level first, then it is a simple sensor swap - usually one of the easiest fixes.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →