P2A07

P2A07: O2 sensor negative voltage b1 sensor 2

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

One of your car's oxygen sensors is sending back a signal that should be impossible - a negative voltage - so the computer flagged the sensor on bank 1 (the side of the engine with cylinder 1), sensor 2. The sensor or its wiring needs checking. The car usually still drives, but fuel economy and emissions control suffer while the computer runs on a backup strategy.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor. Tests: Ground offset between the sensor and the engine computer (corroded or loose ground)
  2. Visually inspect the bank 1 (the side of the engine with cylinder 1) sensor 2 wiring and connector for chafing, melted insulation, corrosion, or oil contamination. Tests: Failed oxygen sensor on bank 1 (the side of the engine with cylinder 1), sensor 2 (most…
  3. With the key on and the sensor unplugged, check the harness side for the reference voltage and ground per the factory service manual - compare against the matching sensor on the other bank. Tests: Signal wire shorted to a negative reference or pinched against another harness
  4. Watch live data: a healthy sensor switches or holds a plausible value, while a negative reading confirms the fault is in the circuit, not the mixture. Tests: Exhaust leak ahead of the sensor skewing the reading
  5. Repair the wiring or replace the bank 1 (the side of the engine with cylinder 1) sensor 2, clear the code, and confirm the reading returns to a normal range on a test drive.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $250
Labor$80 – $200

Oxygen sensor replacement (bank 1 sensor 2). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2A07 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — An oxygen sensor swap is basic hand-tool work once the fault is confirmed; the diagnosis is electrical and takes a scan tool and a multimeter.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →