Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonNo effect on engine performance, but the converter clutch cannot lock up - fix when convenient, not an emergency.
The torque converter clutch circuit has low voltage - the lock-up clutch cannot engage, hurting fuel economy.
Key facts
P2769 means torque Converter Clutch Circuit Low. The torque converter clutch circuit has low voltage - the lock-up clutch cannot engage, hurting fuel economy. WrenchFair's published fair-price range for this repair is $40–$400 parts and $100–$600 labor at independent shops.
WrenchFair rates P2769 a 3-of-5 DIY difficulty (“Harness checks and resistance tests are DIY; the solenoid may be inside the pan and TCM testing needs an advanced scanner.”) with a “Diagnose soon” driveability rating: No effect on engine performance, but the converter clutch cannot lock up - fix when convenient, not an emergency. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
malfunction indicator lamp (MIL) illuminated
minimal decrease in fuel economy
this will not affect engine performance
Likely causes
Wiring harness to transmission damaged, loose connection, open or shorted circuit
Torque converter clutch (TCC) solenoid
Transmission control module (TCM)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 8 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the transmission wiring harness for damage or loose connections; use a factory wiring diagram to locate the power source and all connection points. Tests: Wiring harness to transmission damaged, loose connection, open or shorted circuit
Disconnect the transmission harness at the transmission connector, power source, and TCM; check continuity of the internal transmission wiring by locating the + and - pins for the TCC solenoid. Tests: Wiring harness to transmission damaged, loose connection, open or shorted circuit
With the DVOM set to ohms, check resistance on the TCC solenoid pins - if extremely high or over limit (OL), suspect the internal harness or TCC solenoid (removing the transmission oil pan may be necessary). Tests: Wiring harness to transmission damaged, loose connection, open or shorted circuit
Test the wiring between the TCM and the transmission case connector; check for a short to ground - resistance to a known good ground should be very high or OL. Tests: Wiring harness to transmission damaged, loose connection, open or shorted circuit
Check TCC solenoid resistance at the transmission case after removing the harness plug; compare to manufacturer specifications.
Check for voltage on the power side circuit of the TCC solenoid with key on/engine off - battery voltage should be present.
Monitor the TCM with an advanced scan tool to confirm it is commanding the TCC solenoid and compare commanded vs actual feedback; the solenoid is normally duty-cycle controlled.
To verify the TCM is sending the signal, use a graphing multimeter set to duty cycle - if it stays at 0% or 100% or is intermittent, re-check connections; if wiring and solenoid are good, the TCM may be at fault.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $400
Labor$100 – $600
TCC solenoid or transmission wiring harness repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2769 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Harness checks and resistance tests are DIY; the solenoid may be inside the pan and TCM testing needs an advanced scanner.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →