P2768

P2768: Input Turbine Shaft Speed Sensor B Circuit Intermittent

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The input/turbine speed sensor B signal is intermittent or erratic - shifting problems may come and go.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 11 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for Technical Service Bulletins for the particular vehicle - this may be a known issue with a known fix.
  2. Perform a visual inspection of system wiring and connectors; repair any obviously shorted or open circuits before proceeding. Tests: Damaged, loose, or burnt wiring and/or connectors
  3. Test the battery and inspect battery cables and cable ends; test alternator output.
  4. Retrieve all stored codes and note freeze frame data.
  5. Use the scanner data stream to determine which circuit is malfunctioning; narrow the data stream to pertinent data.
  6. Remove the sensor and check for metal debris on the magnetic contacts; clean excessive debris before reinstallation; inspect the reluctor wheel notches for damage or wear.
  7. Check for transmission fluid in the connector area - some input speed sensors leak internally.
  8. Perform a wiggle test on the harness while watching the sensor signal with a scanner or meter to catch the fault.
  9. Test individual sensor resistance and circuit voltage with the DVOM per manufacturer specifications; replace sensors that fail.
  10. Disconnect related controllers before testing resistance or continuity.
  11. If all circuits and sensors are good, suspect a faulty PCM or PCM programming error.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $250
Labor$100 – $500

Input/turbine speed sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2768 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Intermittent faults are the hardest to pin down - wiggle tests and noting when it occurs help, but the fault may hide during testing.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →