P2741: Transmission Fluid Temperature Sensor B Circuit Range Performance
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonModerate to severe - wrong shift points and line pressure can damage the transmission. Address as soon as possible.
The transmission fluid temperature sensor B signal is out of range - wrong temperature readings mean wrong shift points and possible limp mode.
Key facts
P2741 means transmission Fluid Temperature Sensor B Circuit Range Performance. The transmission fluid temperature sensor B signal is out of range - wrong temperature readings mean wrong shift points and possible limp mode. WrenchFair's published fair-price range for this repair is $40–$300 parts and $100–$600 labor at independent shops.
WrenchFair rates P2741 a 3-of-5 DIY difficulty (“Wiring checks and sensor tests are DIY; the sensor is often inside the pan (fluid drain, gasket) - moderate effort.”) with a “Diagnose soon” driveability rating: Moderate to severe - wrong shift points and line pressure can damage the transmission. Address as soon as possible. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
illuminate check engine light
improper torque converter clutch operation
harsh or delayed shifts
vehicle stuck in limp mode
Likely causes
Faulty transmission fluid temperature sensor
Transmission problems
Wiring problems
Faulty PCM
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Visually inspect the transmission fluid temperature sensor and wiring for loose connections or damaged wiring; repair, clear, and see if it returns. Tests: Faulty transmission fluid temperature sensor
Check Technical Service Bulletins for the issue.
Use a scan tool to monitor the transmission temperature data parameter and compare it to engine temperature on a cold start - both should read near ambient; if the TFT reads implausible, the circuit or sensor is suspect. Tests: Faulty transmission fluid temperature sensor
Disconnect the TFT sensor - the scan tool value should drop to a very low value. Then jumper across the terminals - if the tool shows a very high temperature, the wiring and PCM are good, so the sensor itself is likely bad. Tests: Faulty transmission fluid temperature sensor
Test the sensor: disconnect it and measure resistance between its two terminals while the engine warms up - resistance should decrease smoothly.
Check the reference side: with ignition on, verify 5-volt reference from the PCM at the sensor terminals; with ignition off, check continuity between sensor and PCM terminals.
If everything in the circuit checks out, the transmission itself may have a problem - especially if other transmission codes are set with this one.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $300
Labor$100 – $600
Transmission fluid temperature sensor replacement (often inside the pan). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2741 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Wiring checks and sensor tests are DIY; the sensor is often inside the pan (fluid drain, gasket) - moderate effort.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →