P2587

P2587: Turbo Boost Control Position Sensor Circuit B Range/performance

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The second turbo boost sensor reading is out of range - could be bad wiring, a bad sensor, or an actual boost problem.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
  2. Refer to a vehicle-specific repair guide to identify which sensor is the B sensor.
  3. Verify actual turbo boost pressure with a mechanical gauge against manufacturer specs; if boost is off, find the mechanical cause (exhaust restrictions, wastegate, intake leaks, turbo) before touching the sensor. Tests: Mechanical boost problem (exhaust restriction, wastegate issue, intake leak, bad turbo)
  4. If boost is good, locate the TBCPS B sensor (usually screwed or bolted into the turbocharger housing) and inspect the connector and wiring for damage or corrosion. Tests: Open in the signal circuit to the TBCPS B sensor
  5. Clean the terminals with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease.
  6. Clear the code with a scan tool; if it does not return, the connection was the problem.
  7. If it returns, test the sensor power, ground, and signal circuits with a digital multimeter per manufacturer specs; repair wiring as needed.
  8. If all tests pass, the TBCPS B sensor has likely failed - replace it. PCM failure is unlikely.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $200
Labor$80 – $250

Turbo boost control position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2587 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Connector inspection is DIY; boost pressure testing with a mechanical gauge and circuit tests are intermediate; PCM is shop-level.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →