P2566: Turbo Boost Control Position Sensor Circuit Intermittent
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonPoor performance and hesitation can make merging and passing unsafe. Intermittent faults are usually connection-related; diagnose soon.
The turbo boost sensor signal keeps cutting in and out - check the wiring and connections first.
Key facts
P2566 means turbo Boost Control Position Sensor Circuit Intermittent. The turbo boost sensor signal keeps cutting in and out - check the wiring and connections first. WrenchFair's published fair-price range for this repair is $40–$200 parts and $80–$250 labor at independent shops.
WrenchFair rates P2566 a 4-of-5 DIY difficulty (“Connector inspection and wiggle tests are DIY; boost testing and circuit tests are intermediate; PCM is shop-level.”) with a “Diagnose soon” driveability rating: Poor performance and hesitation can make merging and passing unsafe. Intermittent faults are usually connection-related; diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
malfunction indicator light on
poor performance
hesitation during acceleration
decrease in fuel economy
Likely causes
Open in the signal circuit to the TBCPS sensor
Open in power or ground at the TBCPS sensor
Loose or corroded connector (intermittent contact)
Short to voltage or ground in the signal circuit
Failed TBCPS sensor
Mechanical boost problem (exhaust restriction, wastegate issue, intake leak, bad turbo)
Failed PCM (unlikely)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 9 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
Locate the TBCPS sensor (usually screwed or bolted into the turbocharger housing). Tests: Open in the signal circuit to the TBCPS sensor
Wiggle the harness and connector while watching the sensor signal or codes to reproduce the intermittent fault. Tests: Loose or corroded connector (intermittent contact)
Inspect the connector and wiring for scraping, rubbing, bare wires, burn spots, or melted plastic; check terminals for burning or green corrosion. Tests: Loose or corroded connector (intermittent contact)
Clean the terminals with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease.
Clear the code with a scan tool; if it does not return, the connection was the problem.
If it returns, verify actual boost pressure with a mechanical gauge against manufacturer specs to rule out mechanical causes.
Test the TBCPS power, ground, and signal circuits with a digital multimeter per manufacturer specs; repair wiring as needed.
If all tests pass, the TBCPS sensor has likely failed - replace it. PCM failure is unlikely.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $200
Labor$80 – $250
Turbo boost control position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2566 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Connector inspection and wiggle tests are DIY; boost testing and circuit tests are intermediate; PCM is shop-level.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →