P2565

P2565: Turbo Boost Control Position Sensor Circuit High

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The turbo boost sensor signal is stuck too high - expect poor performance and hesitation.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
  2. Locate the TBCPS sensor (usually screwed or bolted into the turbocharger housing). Tests: Failed TBCPS sensor (likely)
  3. Visually inspect the connector and wiring for scraping, rubbing, bare wires, burn spots, or melted plastic. Tests: Corroded or damaged connector/terminals
  4. Pull the connector apart and inspect the terminals for burning or green corrosion; clean with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease. Tests: Corroded or damaged connector/terminals
  5. Clear the code with a scan tool; if it does not return, the connection was the problem.
  6. If it returns, test the TBCPS power and ground circuits KOEO per manufacturer specs (12 V or 5 V); repair opens in wiring.
  7. Test the signal wire for a short to power or an open; repair if found.
  8. If all tests pass, the TBCPS sensor has likely failed - replace it. PCM failure is unlikely.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $200
Labor$80 – $250

Turbo boost control position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2565 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Visual inspection and connector cleaning are DIY; multimeter circuit tests need basic electrical skills; PCM is shop-level.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →