P2563

P2563: Turbo Boost Control Position Sensor Circuit Range/performance

For your specific vehicle: P2563 on a 2004–2016 Chevrolet 2500

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The turbo boost sensor reading is out of range - could be bad wiring, a bad sensor, or an actual boost problem.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
  2. Verify actual turbo boost pressure with a mechanical gauge against manufacturer specs; if boost is off, find the mechanical cause (exhaust restrictions, wastegate, intake leaks, turbo) before touching the sensor. Tests: Mechanical boost problem (exhaust restriction, wastegate issue, intake leak, bad turbo)
  3. If boost is good, locate the TBCPS sensor (usually screwed or bolted into the turbocharger housing) and inspect the connector and wiring for damage or corrosion. Tests: Open in the signal circuit to the TBCPS sensor
  4. Clean the terminals with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease.
  5. Clear the code with a scan tool; if it does not return, the connection was the problem.
  6. If it returns, test the TBCPS power and ground circuits KOEO per manufacturer specs (12 V or 5 V).
  7. If power and ground pass, test the signal wire (should read 5 V disconnected); repair the open if not.
  8. If all tests pass, the TBCPS sensor has likely failed - replace it. PCM failure is unlikely.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $200
Labor$80 – $250

Turbo boost control position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2563 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Connector inspection is DIY; boost pressure testing with a mechanical gauge and circuit tests are intermediate; PCM is shop-level.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →