P247E

P247E: Exhaust Gas Temperature Out of Range Bank 2 Sensor 3

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The third exhaust temperature sensor on bank 2 (the side without cylinder #1) is reading outside the normal range.

Model notes: Applies to Ford, VW/Volkswagen, Audi, Porsche, Chevy, Nissan - diesel, gasoline, and turbocharged engines.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research Technical Service Bulletins for the specific vehicle by year, model, and powertrain.
  2. Locate the exhaust gas temperature sensor (typically a 2-wire sensor in the exhaust down pipe) and perform a thorough visual inspection of wiring for scraping, rubbing, bare wires, or burn spots. Tests: Defective exhaust gas temperature sensor
  3. Check connectors for security, corrosion, and damaged pins. Tests: Corroded or damaged connector
  4. Remove the sensor and inspect for excessive carbon buildup; clean as needed. Tests: Excessive carbon buildup on sensor
  5. Identify and repair any exhaust leaks near the sensor.
  6. Check for a blown fuse or fuse-able link in the circuit if applicable.
  7. Test the sensor per vehicle technical data - voltage output should vary proportional to temperature; resistance should vary with temperature per the sensor type.
  8. Repair or replace faulty wiring; replace the sensor if it fails testing.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$80 – $200

Exhaust gas temperature sensor replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P247E ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Locating the sensor, visual wiring inspection, carbon-buildup check, and TSB research are DIY-friendly; voltage/resistance testing per specs is intermediate.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →