P229B

P229B: Fuel Pressure Regulator 2 Exceeded Control Limits - Pressure Too High

DIY difficulty 5/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Fuel pressure regulator 2 is running too much fuel pressure (diesel vehicles), which can trigger reduced engine power and limp mode.

Model notes: Reported exclusively on diesel vehicles: Volkswagen, GMC, Chevrolet, Cadillac, Ford, BMW.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Search for TSBs matching the code, vehicle, and symptoms - a known fix can shortcut the diagnosis.
  2. Record all stored codes and freeze-frame data, then clear codes and test drive until the code returns or the PCM enters readiness mode.
  3. Visually inspect related wiring and connectors; repair any wiring that is cut, burned, or damaged. Tests: Shorted or open wiring and/or connectors in the fuel pressure regulator control circuit
  4. Use the DVOM to test voltage and ground circuits at electronic fuel regulator 2 and fuel pressure sensor/s; if no voltage, check system fuses and replace as required. Tests: Shorted or open wiring and/or connectors in the fuel pressure regulator control circuit
  5. If voltage is detected, test the corresponding circuit at the PCM connector - no voltage there indicates an open circuit between the sensor and PCM; voltage there points to a defective PCM or PCM programming error.
  6. Test the regulator and sensor against manufacturer specifications with the DVOM; if the rail is suspected, qualified personnel only should use a manual fuel pressure gauge (rail and components may be under extremely high pressure).

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$150 – $600
Labor$150 – $600

Fuel pressure regulator or fuel pressure sensor replacement (diesel). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P229B ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

5 of 5 — High-pressure diesel systems are professional-only; DIY work is limited to code recording and visual wiring checks.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →