P2240

P2240: O2 sensor positive current control circuit open bank 2 sensor 1

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The upstream O2 sensor on bank 2 has an open or faulty positive current control circuit - the sensor cannot report exhaust oxygen properly.

Model notes: Seen on 2004 BMW 330Ci. Also common on Mazda, VW, Acura, Kia, Toyota, BMW, Peugeot, Lexus, Audi.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Retrieve all stored codes and freeze frame data; clear the codes and test drive.
  2. Perform a visual inspection of HO2S related wiring and connectors - replace cut, burned, or damaged wiring. Tests: Burnt, chafed, broken, or disconnected wiring or connectors
  3. Unplug the HO2S and use the DVOM to check resistance between the positive current control circuit and ground circuits - continuity suggests a defective HO2S. Tests: Defective oxygen sensor
  4. Start the engine, allow it to reach normal operating temperature, and observe oxygen sensor input data on the scanner. Tests: Defective oxygen sensor
  5. If the HO2S displays battery voltage or no voltage, test live data at the HO2S connector; if unchanged, suspect an internal HO2S short and replace the sensor.
  6. Consider a faulty PCM or programming error only after the sensor and wiring check out.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $200
Labor$50 – $150

Oxygen sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2240 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Visual inspection and O2 sensor replacement are intermediate work; resistance testing between circuits requires electrical familiarity.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →