P219E

P219E: Cylinder 3 Imbalance Error

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Cylinder three is burning a different air-fuel mix than the other cylinders, and the computer is flagging it.

Model notes: Reported on 2015 Audi S3 (suspected failed injector), 2015 Subaru Legacy 143k miles; applies to Toyota, Audi, Kia, VW, Lexus.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Address any stored misfire, throttle position, MAP, or MAF codes before diagnosing P219E; the engine must run smoothly and any rich or lean condition must be repaired first.
  2. Search for TSBs matching the code, vehicle, and symptoms - a known fix can shortcut the diagnosis.
  3. Record all stored codes and freeze-frame data, then clear codes and test drive until the code returns or the PCM enters readiness mode.
  4. Visually inspect related wiring and connectors; repair any wiring that is cut, burned, or damaged. Tests: Burnt, chafed, broken, or disconnected wiring or connectors
  5. With the engine at operating temperature and idling, observe oxygen sensor data on the scanner data stream; sensors that fail to cycle adequately with a healthy engine should be considered defective.
  6. Use an oscilloscope to test for voltage spikes or glitches in the CKP and CMP sensor inputs.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$100 – $400

Sensor replacement or mechanical engine repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P219E ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Per-cylinder imbalance often traces to mechanical engine issues; scope testing CKP/CMP signals is professional-level work.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →