Diagnose soonWrong fuel mixture stresses the catalytic converter over time. Diagnose soon.
The main oxygen sensor is stuck saying 'too lean,' so the computer keeps adding fuel the engine doesn't need. The real question is whether the sensor is lying or the engine truly is lean - fuel-trim readings tell the tale.
Model notes: The propane enrichment test is the definitive DIY check for a stuck-lean sensor - a good sensor must respond to a real mixture change.
Key facts
P2195 means o2 sensor signal stuck lean, bank 1 sensor 1. The main oxygen sensor is stuck saying 'too lean,' so the computer keeps adding fuel the engine doesn't need. The real question is whether the sensor is lying or the engine truly is lean - fuel-trim readings tell the tale. WrenchFair's published fair-price range for this repair is $10–$120 parts and $100–$280 labor at independent shops.
WrenchFair rates P2195 a 3-of-5 DIY difficulty (“The key question is whether the sensor is lying or the engine is truly lean - fuel trims answer it.”) with a “Diagnose soon” driveability rating: Wrong fuel mixture stresses the catalytic converter over time. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 515 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine) — see the latest ones
On your 2019–2024 Toyota RAV4 (2.5L 4-cyl (A25A-FKS)) — O2 (oxygen) sensors:Owner-verified
Toyota uses an air/fuel ratio sensor upstream, not a conventional narrow-band O2: Bank 1 Sensor 1 threads into the exhaust manifold ahead of the catalytic converter, and Bank 1 Sensor 2 sits downstream of the cat. Unclip the wiring connector from its mounting bracket first, then back the sensor out with a 22 mm O2 sensor socket. Owners on rav4world.com describe the upstream swap as a roughly 20-minute, sub-$100 DIY versus about $400 at a dealer.
Do this test first: Check fuel trims: high positive trims mean the ECM believes the lean signal and is adding fuel
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2195 on the 2019–2024 Toyota RAV4 — but the community-sourced O2 (oxygen) sensors note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Air/fuel ratio sensor (M18x1.5): verify — Confirm against factory service info for this engine before torquing.
Tips
Order by position: upstream B1S1 is an air/fuel ratio sensor — Denso 234-9307 (Toyota 89467-06250 / 89467-33290) — while downstream B1S2 is a conventional heated O2 sensor; they are not interchangeable.
A failed upstream A/F sensor commonly throws downstream codes (e.g., P0137 B1S2 low voltage) — rav4world members resolved a persistent P0137 by replacing the upstream A/F sensor, so check upstream sensor data before replacing the downstream one.
Thread size is M18x1.5 with a 22 mm hex; clear codes after install and drive full heat cycles before judging the fix — a lazy upstream sensor can also set P0171 lean codes.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
rough idle
hesitation
poor fuel economy
engine may actually run rich from over-fueling
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Exhaust leak ahead of the sensor diluting the exhaust with outside air
Vacuum leak genuinely leaning the mixture
Low fuel pressure genuinely leaning the mixture
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check fuel trims: high positive trims mean the ECM believes the lean signal and is adding fuel
Introduce a brief rich condition (a shot of propane at the intake) - a working sensor should swing rich immediately; a stuck sensor will not respond Tests: Failed upstream O2 sensor stuck lean (most common)
Check for exhaust leaks ahead of the sensor and vacuum leaks at the intake Tests: Exhaust leak ahead of the sensor diluting the exhaust with outside air
If the sensor does not respond to the propane test, replace it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2019–2024 Toyota RAV4: O2 (oxygen) sensors — test first, then buy for this job.
Expensive fork: Catalytic converter — only if the downstream waveform shows a dead cat after a good sensor and no exhaust leak.
The price range below is a national planning range for P2195 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$10 – $120
Labor$100 – $280
Often a hose or gasket; sensor or fuel faults cost more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2195 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The key question is whether the sensor is lying or the engine is truly lean - fuel trims answer it.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →