P2195

P2195: O2 sensor signal stuck lean, bank 1 sensor 1

For your specific vehicle: P2195 on a 2019–2024 Toyota RAV4

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The main oxygen sensor is stuck saying 'too lean,' so the computer keeps adding fuel the engine doesn't need. The real question is whether the sensor is lying or the engine truly is lean - fuel-trim readings tell the tale.

VW/Audi note (VCDS): Use the propane test while graphing the sensor: no response to enrichment condemns the sensor conclusively.
Model notes: The propane enrichment test is the definitive DIY check for a stuck-lean sensor - a good sensor must respond to a real mixture change.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check fuel trims: high positive trims mean the ECM believes the lean signal and is adding fuel
  2. Introduce a brief rich condition (a shot of propane at the intake) - a working sensor should swing rich immediately; a stuck sensor will not respond Tests: Failed upstream O2 sensor stuck lean (most common)
  3. Check for exhaust leaks ahead of the sensor and vacuum leaks at the intake Tests: Exhaust leak ahead of the sensor diluting the exhaust with outside air
  4. If the sensor does not respond to the propane test, replace it

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$10 – $120
Labor$100 – $280

Often a hose or gasket; sensor or fuel faults cost more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2195 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — The key question is whether the sensor is lying or the engine is truly lean - fuel trims answer it.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →