P216D

P216D: Fuel Injector Group F Circuit/open

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The wiring or power supply to fuel injector group F has an open, so those injectors are not firing.

Model notes: Applies to Dodge Ram (Cummins), GMC/Chevrolet (Duramax), VW, Audi, Ford (Powerstroke), Mercedes Sprinter, Peugeot, Alfa Romeo, Nissan, Saab, Mitsubishi.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Locate which group of injectors the manufacturer designates group F, then find the physical location of the injectors and their circuits (may involve removing engine covers and/or components). Tests: Defective or damaged fuel injector(s)
  2. Inspect the harness for broken wires; fuel injector harnesses run close to extreme temperatures and are volatile to physical damage. Repair worn-away insulation with heat-shrink tubing. Tests: Defective or damaged fuel injector(s)
  3. Check for water or fluids trapped in the injector valleys that accelerate connector corrosion; verify connector tabs seal properly and clean with electrical contact cleaner. Tests: Defective or damaged fuel injector(s)
  4. Verify circuit integrity per the vehicle service manual; one example is to disconnect the supply voltage circuit from the ECM and at the fuel injector, then check with a multimeter. Tests: Defective or damaged fuel injector(s)
  5. Perform a continuity test: set the multimeter to resistance, touch one tip to one end of the circuit and the other tip to the other end. A higher-than-desired value indicates an open; trace the wire to find the fault.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$75 – $350

Fuel injector or wiring harness repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P216D ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Harness inspection and continuity tests are intermediate; gaining access to injectors can require removing covers/components.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →