P2163: Throttle pedal position sensor A maximum stop performance
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThis code can leave the vehicle undriveable with severely limited or disabled acceleration.
The computer is seeing an incorrect voltage from throttle/pedal sensor A at the wide-open throttle end of travel - it cannot trust the signal at full throttle.
Model notes: Some manufacturers require the throttle body, throttle actuator motor, and all throttle position sensors to be replaced as a single unit.
Key facts
P2163 means throttle pedal position sensor A maximum stop performance. The computer is seeing an incorrect voltage from throttle/pedal sensor A at the wide-open throttle end of travel - it cannot trust the signal at full throttle. WrenchFair's published fair-price range for this repair is $40–$600 parts and $100–$400 labor at independent shops.
WrenchFair rates P2163 a 3-of-5 DIY difficulty (“Inspecting wiring and cleaning the throttle body are DIY-friendly; live sensor signal testing with a multimeter is intermediate.”) with a “Diagnose soon” driveability rating: This code can leave the vehicle undriveable with severely limited or disabled acceleration. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
lack of throttle response
limited or no acceleration
engine stall when allowed to idle
hesitation when accelerating
cruise control inoperative
Likely causes
Defective TPS or PPS
Open or shorted circuits between the TPS, PPS, and the PCM
Corroded electrical connectors
Faulty drive-by-wire actuator motor
Carbon buildup on the throttle plate
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 8 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your vehicle matching the symptoms and codes.
Visually inspect all system-related wiring and connectors. Tests: Corroded electrical connectors
Check the throttle plate for signs of carbon buildup or damage - clean the throttle body per manufacturer recommendations. Tests: Carbon buildup on the throttle plate
Retrieve all stored codes and freeze-frame data; clear codes and test drive.
Watch the scanner data stream for voltage spikes and inconsistencies between the TPS, PPS, and PCM.
Use a DVOM on the sensor signal wires - observe voltage while slowly actuating the throttle from closed to wide open; look for spikes (typically about 0.5 volts closed to 4.5 volts at WOT, but check specs).
If the sensor checks out, test individual circuits with the DVOM using wiring diagrams.
Suspect a defective PCM only after all sensors and circuits check out.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $600
Labor$100 – $400
Throttle body assembly or pedal position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2163 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Inspecting wiring and cleaning the throttle body are DIY-friendly; live sensor signal testing with a multimeter is intermediate.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →