P2142

P2142: EGR throttle position control circuit A high

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The signal to the EGR throttle valve is too high - the computer is seeing more voltage than it expects on that control circuit.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your vehicle.
  2. Locate the EGR throttle control valve - between the intake manifold and the air filter, similar to a throttle body. Tests: Short to voltage in the signal circuit to the EGR throttle control valve
  3. Visually inspect the connectors and wiring for scraping, rubbing, bare wires, burn spots, or melted plastic. Tests: Corroded or damaged connector or wiring
  4. Pull the connectors apart and inspect the terminals for burning or corrosion - clean and apply dielectric grease. Tests: Corroded or damaged connector or wiring
  5. Clear the codes and see if P2142 returns.
  6. With the harness disconnected, test the EGR throttle control valve signal circuit with a DVOM - check for the 5-volt reference.
  7. Verify a good ground at the valve; wiggle the harness while testing for an intermittent connection.
  8. If all tests pass and the code returns, the EGR throttle control valve is likely failed.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $500
Labor$100 – $300

EGR throttle control valve replacement, wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2142 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Locating the valve and visually inspecting wiring and connectors is DIY-friendly; circuit testing needs a multimeter.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →