P213A

P213A: Exhaust Gas Recirculation (egr) Throttle Control Circuit B Open

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The EGR throttle valve B on your diesel has an open electrical circuit, so the exhaust gas recirculation system is not working.

Model notes: Typically applies to diesel engines built after 2004, including certain Ford, Dodge, GM, Mercedes, Mitsubishi, Nissan, Suzuki, and VW vehicles.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check technical service bulletins for the vehicle in question.
  2. Locate the EGR throttle control valve (between the intake manifold and the air filter). Visually inspect the connectors and wiring for scraping, rubbing, bare wires, burn spots, or melted plastic. Tests: Open in the signal circuit between the EGR throttle control valve and the PCM
  3. Pull the connectors apart and inspect terminals for burn marks or corrosion; clean with electrical contact cleaner, let dry, and apply dielectric silicone grease.
  4. Clear the codes and see if P213A returns; if not, the connections were most likely the problem.
  5. If it returns, disconnect the valve harness and use the DVOM to test the valve signal circuit (red lead to the valve signal circuit, black lead to a good ground). No 5 volts or 12 volts present means repair the wiring from the PCM to the valve, or suspect a bad PCM.
  6. Verify ground at the valve with a test light connected to 12V battery positive, touching the ground circuit; wiggle the harness to catch intermittent connections.
  7. If all tests pass, the EGR throttle control valve has likely failed; a failed PCM cannot be ruled out until the valve is replaced.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $400
Labor$75 – $300

EGR throttle control valve replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P213A ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Connector cleaning is easy; DVOM signal/ground testing is intermediate.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →