Diagnose soonThrottle faults can trigger limp mode with reduced power. Avoid highways until diagnosed.
Your car's two throttle position sensors disagree with each other, so the computer trusts neither and limits power. A dirty throttle body is a common cause and cheap to clean.
Model notes: Clean the throttle body before replacing it - heavy carbon deposits around the blade are a leading cause of correlation codes and a $10 can of cleaner fixes many of them.
Key facts
P2135 means throttle/pedal position sensor A/B voltage correlation. Your car's two throttle position sensors disagree with each other, so the computer trusts neither and limits power. A dirty throttle body is a common cause and cheap to clean. WrenchFair's published fair-price range for this repair is $10–$250 parts and $80–$250 labor at independent shops.
WrenchFair rates P2135 a 2-of-5 DIY difficulty (“Correlation codes are often intermittent - graphing both sensors during the fault is the key.”) with a “Diagnose soon” driveability rating: Throttle faults can trigger limp mode with reduced power. Avoid highways until diagnosed. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2008–2016 Cadillac Escalade (6.2L V8 (L92/L94/L86)) — "Engine Power is Reduced" - throttle body / pedal sensor (P2135, P2138):Owner-verified
Throttle-body cleaning is a driveway job (remove intake tube, clean the bore, do the idle relearn). Pedal-sensor replacement is a few bolts under the dash. Under the special coverage, a dealer repairs the 2008-2011 TPS condition free within 10 years/120k miles - check your in-service date before paying.
Do this test first: Graph TPS A and B together during a slow throttle sweep - look for the moment they diverge
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2135 on the 2008–2016 Cadillac Escalade — but the community-sourced "Engine Power is Reduced" - throttle body / pedal sensor (P2135, P2138) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Tips
The 'Engine Power is Reduced' message with P2135 (throttle position correlation) or P2138 (pedal position correlation) puts the truck in limp mode. 1A Auto ranks it as problem #3 on the 2007-2014 Escalade.
GM acknowledged a throttle-position-sensor defect: the special coverage program covers 2008-2011 Escalade/ESV/EXT with this exact condition for 10 years from in-service date or 120,000 miles, repaired free at a dealer. If you already paid, the letter includes a reimbursement form.
On 2016 trucks (K2XX generation), GM's PI PIP5344 points to a different root cause: the wiring harness pinched on a mounting stud at the left IP junction block. If sensor swaps don't stick, inspect that harness for chafing before throwing more parts.
The DIY ladder: (1) clean the throttle bore - carbon buildup is the most common owner-found cause of P2138-series limp mode; (2) inspect the throttle-body and pedal-sensor connectors for corrosion; (3) replace the pedal sensor (a 10mm-bolts job per owner videos); (4) replace the throttle body.
After any repair, do the idle/throttle relearn (battery disconnect, key-on wait, gentle pedal cycle) or the reduced-power message may return immediately on a repair that was actually correct.
Typical difficulty: Moderate — based on 307 code guides for the intake repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
reduced power mode
intermittent power loss
throttle response cuts in and out
stalling when coming to a stop
throttle stuck at current rpm
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
One TPS element worn or failing (most common - usually the assembly is replaced)
Intermittent wiring fault on one sensor circuit
Corroded connector affecting one sensor
Throttle body coking causing the blade to stick and confuse correlation checks
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Graph TPS A and B together during a slow throttle sweep - look for the moment they diverge Tests: Throttle body coking causing the blade to stick and confuse correlation checks
Clean throttle body coking first - carbon buildup is a common correlation-code cause and cleaning is cheap Tests: Throttle body coking causing the blade to stick and confuse correlation checks
Check the connector for corrosion or loose pins Tests: Corroded connector affecting one sensor
If cleaning and wiring are good, replace the throttle body and perform the relearn procedure Tests: Throttle body coking causing the blade to stick and confuse correlation checks
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2008–2016 Cadillac Escalade: "Engine Power is Reduced" - throttle body / pedal sensor (P2135, P2138) — test first, then buy for this job.
The price range below is a national planning range for P2135 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$10 – $250
Labor$80 – $250
Cleaning is nearly free; throttle body replacement costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2135 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Correlation codes are often intermittent - graphing both sensors during the fault is the key.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →