P2132

P2132: Throttle position sensor F circuit low input

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The third throttle position sensor circuit is reporting a voltage that is too low - the signal may be shorted to ground or the reference voltage may be missing.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Inspect the throttle position sensor, wiring connector, and wiring for breaks - repair or replace as necessary.
  2. Check the voltage at the TPS against service manual specifications. Tests: Lost 5-volt reference voltage
  3. If the TPS was recently replaced, check whether it needs to be aligned or adjusted per the service manual. Tests: TPS not mounted securely or not properly adjusted after installation
  4. Check for the 5-volt reference at the connector - if missing, investigate the reference circuit. Tests: Lost 5-volt reference voltage
  5. If multiple sensor low-voltage codes are stored, investigate the shared 5-volt reference circuit.
  6. If there are no symptoms, the fault may be intermittent - check the wiring for rubbing or grounding.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$80 – $250

Throttle position sensor replacement, wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2132 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Inspecting the sensor, connector, and wiring is DIY-friendly; circuit voltage testing needs a multimeter and service manual.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →