P212C: Throttle Position Sensor/switch G Circuit Low
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonStalling, surging, and loss of acceleration are likely. Diagnose immediately.
The throttle position sensor G is reporting abnormally low voltage - likely a short to ground or lost reference voltage.
Key facts
P212C means throttle Position Sensor/switch G Circuit Low. The throttle position sensor G is reporting abnormally low voltage - likely a short to ground or lost reference voltage. WrenchFair's published fair-price range for this repair is $20–$120 parts and $50–$200 labor at independent shops.
WrenchFair rates P212C a 2-of-5 DIY difficulty (“Wiring inspection and connector checks are easy; TPS alignment on some vehicles requires a service manual.”) with a “Diagnose soon” driveability rating: Stalling, surging, and loss of acceleration are likely. Diagnose immediately. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
rough or low idle
stalling
surging
little or no acceleration
other symptoms may also be present
Likely causes
TPS circuit short to ground or another wire
Faulty TPS
TPS not mounted securely
Damaged computer (PCM)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Carefully check the throttle position sensor, wiring connector, and wiring for breaks; repair or replace as necessary.
Check the voltage at the TPS per the service manual for the vehicle; if the voltage is too low, that indicates the problem.
If the TPS was recently replaced, it may need to be adjusted or aligned per the installation instructions; consult a repair manual for specifics.
If there are no symptoms, the problem may be intermittent; clearing the code may resolve it temporarily. Check the wiring to be sure it is not rubbing on anything or grounding.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$20 – $120
Labor$50 – $200
Throttle position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P212C ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Wiring inspection and connector checks are easy; TPS alignment on some vehicles requires a service manual.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →