P212B: Throttle Position Sensor/switch G Circuit Range/performance
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonOut-of-range throttle signal can cause stumbling, black smoke, or a no-start. Diagnose immediately.
The throttle position sensor G is sending a reading that is out of range or does not match engine speed.
Key facts
P212B means throttle Position Sensor/switch G Circuit Range/performance. The throttle position sensor G is sending a reading that is out of range or does not match engine speed. WrenchFair's published fair-price range for this repair is $20–$120 parts and $50–$200 labor at independent shops.
WrenchFair rates P212B a 3-of-5 DIY difficulty (“Scan tool voltage checks are easy; scope diagnosis of intermittent dropouts is intermediate.”) with a “Diagnose soon” driveability rating: Out-of-range throttle signal can cause stumbling, black smoke, or a no-start. Diagnose immediately. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
malfunction indicator lamp illumination
intermittent stumble on acceleration or deceleration
black smoke on acceleration
no start
Likely causes
TPS has intermittent open or short internally
Harness rubbing and causing an open or short in the wiring
Bad connection at the TPS
Bad PCM (less likely)
Water or corrosion in the connector or sensor
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
With a scan tool, check idle and WOT readings for the TPS; at idle about 0.5 volts, at wide open throttle about 4.5 volts. If not close to spec, replace the TPS and re-check.
Check for an intermittent open or short in the TPS signal with an oscilloscope; scan tools can miss intermittent dropouts. The signal should sweep up and down smoothly with no dropouts or spikes. Tests: TPS has intermittent open or short internally
Perform a wiggle test on the connector and harness while watching the pattern; if it drops out, replace the TPS and re-check. Tests: Water or corrosion in the connector or sensor
If there is no TPS signal, check for the 5-volt reference at the connector; if present, check the ground circuit for opens or shorts. Tests: TPS has intermittent open or short internally
Verify the signal circuit is not at 12V (battery voltage); if it is, trace the circuit for a short to voltage and repair.
Look for water in the connector and replace the TPS as necessary.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$20 – $120
Labor$50 – $200
Throttle position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P212B ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Scan tool voltage checks are easy; scope diagnosis of intermittent dropouts is intermediate.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →