P212A

P212A: Throttle Position Sensor/switch G Circuit Malfunction

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The computer is not getting a valid signal from the throttle position sensor circuit G.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. With KOEO (key on, engine off), observe TPS voltage on the scan tool; with the throttle closed it should be about 0.45 volts and gradually sweep up to approximately 4.5 to 5 volts as you depress the throttle. Tests: Bad throttle position sensor (TPS)
  2. If you notice a glitch in the TPS sweep voltage (sometimes only a scope can capture an intermittent glitch), replace the TPS.
  3. If the voltage is not about 0.45 volts (plus or minus 0.3) with the throttle closed or the reading is stuck, unplug the TPS connector and check for the 5-volt reference and a good ground at the connector. Tests: Bad throttle position sensor (TPS)
  4. Check the signal circuit for continuity by jumping a fused wire between the ground circuit and the signal circuit of the TPS connector; if the scan tool reading now reads zero, replace the TPS. Tests: MAP or TPS connector corrosion
  5. If the reading does not change to zero, check for an open or short on the signal wire; if none is found, suspect a bad PCM.
  6. If manipulating the TPS wiring harness causes any change in idle, suspect a bad TPS.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$20 – $120
Labor$50 – $200

Throttle position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P212A ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Scan tool voltage sweep checks are easy; wiring and PCM checks are intermediate; some TPS sensors require fine adjustment.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →