P210E

P210E: Throttle/pedal Position Sensor/switch C/f Voltage Correlation

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The computer sees two conflicting signals about how far open the throttle is, so it does not trust either.

Model notes: On an Infiniti this may read Throttle position sensor circuit range/performance; on a Hyundai Electronic throttle control system malfunction power management.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check technical service bulletins for the vehicle and code; some vehicles have a throttle relearn procedure (e.g., on a Nissan, cycle the ignition and pedal through a prescribed sequence) or require dealer reprogramming. Tests: TPS sensors out of correlation; computer needs a relearn procedure or dealer reprogramming
  2. Pull the electrical connector from the throttle body; inspect closely for missing or bent female terminals and corrosion. Clean corrosion with a small pocket screwdriver, apply electrical grease, and reconnect. Tests: Corroded, bent, or pulled-out female terminals in the throttle body wiring connector…
  3. If terminals are bent or missing, replace the throttle body pigtail with one from an auto parts store or the dealer. Tests: Corroded, bent, or pulled-out female terminals in the throttle body wiring connector…
  4. Inspect the throttle body top cover for cracks or warping; a distorted cover compromises the gears and the whole throttle body must be replaced. Tests: Distorted throttle body top cover preventing the drive gears from turning
  5. With a voltmeter, probe the accelerator pedal sensor: it should have a 5V reference and a varying signal that climbs smoothly from about 0.5 to 5.0 volts as the pedal is depressed. Replace it if the voltage spikes or is absent.
  6. Probe the throttle body connector for power to the throttle motor while a helper turns the key on and slightly depresses the pedal; no power suggests a computer fault, power present with no movement suggests a faulty throttle body.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $400
Labor$75 – $350

Throttle body or accelerator pedal sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P210E ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Connector inspection and cleaning are easy; sensor voltage tests and relearn procedures are intermediate; handle throttle body with extreme care.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →