P210D

P210D: Throttle Actuator B Control Motor Circuit High

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The second throttle actuator (motor B) control circuit is seeing too much voltage - a short to power or failed actuator.

Model notes: Shows up more often on certain Ford and Nissan vehicles.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check technical service bulletins for the vehicle in question.
  2. Locate the Throttle Actuator B (front of engine, top of engine, wheel well, or bulkhead). Visually inspect the connector and wiring for scraping, rubbing, bare wires, burn spots, or melted plastic. Tests: Open in the circuit to the throttle actuator
  3. Pull the connector apart and inspect terminals for burn marks or corrosion; clean with electrical contact cleaner, let dry, and apply electrical grease.
  4. Clear the codes and see if P210D returns; if not, the connections were most likely the problem. Relays and relay connections are also a common concern.
  5. If it returns, disconnect the actuator harness and use the DVOM to test actuator motor resistance between the two terminals; infinite resistance or zero ohms means replace the actuator.
  6. Check for 12V at the actuator power supply circuit with the actuator activated via scan tool; repair wiring from PCM or relay to the actuator if voltage is missing.
  7. Verify ground at the actuator with a test light connected to 12V battery positive, touching the ground circuit while actuating; wiggle the harness to catch intermittent connections.
  8. If all tests pass, the actuator has likely failed internally; a failed PCM cannot be ruled out until the actuator is replaced.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $300
Labor$75 – $300

Throttle actuator replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P210D ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Connector cleaning and resistance checks are easy; circuit tracing with relay/PCM wiring is intermediate.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →