P2086

P2086: Exhaust gas temperature (EGT) sensor circuit range/performance bank 2 sensor 2

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The exhaust temperature sensor after the converter on bank 2 (the side without cylinder 1) is reading out of range - usually a failed sensor, a corroded or loose connector, or wiring shorted to ground.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your make and model.
  2. Locate the bank 2 sensor 2 EGT sensor - in the exhaust pipe downstream of the catalytic converter. Tests: Aftermarket exhaust without EGT provisions
  3. Check the connectors and pigtail for corrosion, loose terminals, and missing insulation or bare wires shorting to ground. Tests: Broken wires or missing insulation shorting to ground
  4. Remove the EGT sensor and check its resistance with an ohmmeter against the factory spec.
  5. Heat the sensor with a hair dryer or heat gun while watching the ohmmeter - resistance should drop as it heats and rise as it cools.
  6. With the key on, measure the reference voltage at the engine side of the pigtail against the factory spec.
  7. Replace the sensor if it fails the resistance or response test.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $250
Labor$100 – $300

EGT sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2086 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Locating and replacing the sensor is straightforward; testing the sensor's resistance and heating it to watch the response needs the factory specs.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →