P2059: Reductant injection air pump control circuit open
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe SCR system can be disabled, which raises emissions and can damage the catalyst if ignored - get it diagnosed promptly.
The small air pump that helps atomize the DEF spray has an open in its control circuit - usually a failed pump, a bad air pressure sensor, or broken wiring. DEF is not atomizing properly, so emissions climb and the SCR system can shut down.
Key facts
P2059 means reductant injection air pump control circuit open. The small air pump that helps atomize the DEF spray has an open in its control circuit - usually a failed pump, a bad air pressure sensor, or broken wiring. DEF is not atomizing properly, so emissions climb and the SCR system can shut down. WrenchFair's published fair-price range for this repair is $200–$900 parts and $150–$500 labor at independent shops.
WrenchFair rates P2059 a 4-of-5 DIY difficulty (“Leak inspection is doable; pump and sensor testing needs the factory flowcharts and pin-outs.”) with a “Diagnose soon” driveability rating: The SCR system can be disabled, which raises emissions and can damage the catalyst if ignored - get it diagnosed promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
reduction in fuel efficiency
excessive black smoke from the exhaust
diminished engine performance
other SCR-related codes
Likely causes
Faulty reductant injection air pump (most common)
Defective reductant air pressure sensor
Open or shorted circuits in the air pump control wiring
Internally leaking reductant supply pump
Bad SCR controller/PCM or programming error (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your make and model.
Activate the pump and inspect the whole reductant system for external leaks - repair leaks before continuing. Tests: Faulty reductant injection air pump (most common)
Use a fuel pressure tester to monitor reductant system pressure manually and check the supply pump and injector for leakage. Tests: Internally leaking reductant supply pump
Retrieve all codes and freeze-frame data, record it, clear the codes, and drive to see if P2059 resets.
Test the reductant injection air pump control circuits, components, and sensors against the factory specs.
If the air pressure is within spec and everything else tests good, test the input and output signal circuits with the controllers disconnected.
Only suspect the controller or PCM after the pump, sensor, and wiring are all proven good.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$200 – $900
Labor$150 – $500
Reductant injection air pump or air pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2059 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Leak inspection is doable; pump and sensor testing needs the factory flowcharts and pin-outs.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →