P202A

P202A: Reductant Tank Heater Control Circuit/open

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The heater that keeps your diesel exhaust fluid (DEF) from freezing is not getting power.

Model notes: Diesel vehicles only (Volkswagen, Mercedes-Benz, Dodge, Audi). DEF/SCR systems are used in colder climates.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Retrieve stored codes and freeze frame data, record them, clear the codes, and test-drive until the PCM enters readiness mode or the code resets.
  2. Search a vehicle information source for diagnostic flow-charts, connector pin-out charts, connector face views, and component testing procedures/specifications.
  3. Use the DVOM to test the reductant tank heater element against manufacturer specifications; heater elements outside maximum allowable parameters are defective. Tests: Bad reductant tank heater element
  4. Test reductant heater circuit voltage (usually battery voltage) with the system activated; if conditions do not permit activation, manually activate the heater with the scan tool. Tests: Open or shorted circuits in the reductant tank heater control
  5. If the heater is functional, test input and output signal circuits from the fuse panel, PCM, and ignition switch with the DVOM, disconnecting all controllers first.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $400
Labor$100 – $350

Reductant tank heater element replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P202A ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Element resistance and circuit voltage tests are intermediate; DEF tank access varies.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →