P0DED: Pedestrian Alert Control Module Circuit/Open
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonYou will usually just see a warning light - diagnose it before it turns into a bigger problem.
A wire or plug in the pedestrian alert control module circuit is broken or unplugged, so the car's computer can't see what that part is doing. You will usually just see a warning light.
Key facts
P0DED means pedestrian Alert Control Module Circuit/Open. A wire or plug in the pedestrian alert control module circuit is broken or unplugged, so the car's computer can't see what that part is doing. You will usually just see a warning light. WrenchFair's published fair-price range for this repair is $230–$1380 parts and $140–$720 labor at independent shops.
WrenchFair rates P0DED a 2-of-5 DIY difficulty (“Diagnosis needs a scan tool with hybrid PIDs and the factory service manual; component replacement difficulty varies by vehicle.”) with a “Diagnose soon” driveability rating: You will usually just see a warning light - diagnose it before it turns into a bigger problem. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
warning light on
affected system inoperative
reduced performance
affected system inoperative
Likely causes
open in module control wire (most common)
module failed
pin pushed back out of connector body
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Clear the code and confirm it returns under the same conditions before replacing anything.
2. Inspect the pedestrian alert control module connector and wiring for damage, corrosion, water intrusion, or pins pushed back out of the connector body - pay attention to spots where the harness flexes or rubs. Tests: pin pushed back out of connector body
3. With a scan tool, watch the live pedestrian alert control module reading while wiggling the harness; a reading that jumps or drops out confirms a wiring or connector fault. Tests: open in module control wire (most common)
4. Check the pedestrian alert control module power, ground, and signal wiring for opens and shorts per the factory service manual before condemning the part. Tests: open in module control wire (most common)
5. If the wiring tests good, replace the pedestrian alert control module sensor or component, then retest.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$230 – $1380
Labor$140 – $720
Repairing the open in the pedestrian alert control module wiring. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0DED ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Diagnosis needs a scan tool with hybrid PIDs and the factory service manual; component replacement difficulty varies by vehicle.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →