P0AF2

P0AF2: Drive motor inverter temperature sensor B circuit

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

This sensor is a thermometer for part of the hybrid system, there so the computer can tell if things are getting too hot. This code means the computer no longer trusts its readings (an electrical problem in the wiring), so it's blind to overheating in that spot. The sensor area can sit near high-voltage hardware, so visual checks are fine but keep your hands off anything you can't positively identify as low-voltage.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Park, power down completely, and respect the high-voltage system: the battery pack and orange cables are lethal to touch. Leave anything inside the pack to a trained technician; you can safely check the 12V battery, fuses, and connectors outside the pack. Tests: damaged wiring or a bad connector
  2. Check the 12V battery's health and terminal connections — a weak 12V battery is a classic cause of phantom hybrid codes.
  3. Check the coolant level in the relevant reservoir — low coolant or trapped air skews temperature readings.
  4. Inspect the sensor's connector for corrosion, loose pins, or coolant contamination. Tests: sensor connector corroded or loose
  5. With a scanner that reads hybrid live data, compare this sensor to the other temperature sensors after the car sits overnight — they should all read near the outside air temperature.
  6. A sensor stuck at one value or jumping wildly usually needs replacement, which sits near HV hardware — get a quote.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $200
Labor$75 – $450

sensor failed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0AF2 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Beginner-friendly checks (fuses, connectors, cleaning) are DIY; stop there if the fault is inside the high-voltage system.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →